Morning chaps... many thanks for your thoughts regarding our daughter, possible kidney problems but STILL undergoing tests 🤞🤞
As regards the bike Matt, I've completely deseamed the petrol tank and added a flush fitting filler cap which I think was covered in a previous post a while back. There's been quite a bit of fab/welding work gone in to the frame, the obvious one is the rear loop which I bought in then cut and shut to suit the look I wanted, I then fabricated a little pocket into the rear of the loop to accept a mini LED rear light. I've fabbed up a couple of brackets the welded them to the rear subframe down tubes and to the crossmember above swinging arm pivot to accept the 10mm ally plate that I made to hang the oil tank from. I also made the ally footrest hangers from 10mm ally plate. I also formed the seat/seat hump. Where do I get my ideas? Good question Matt. Lots of places if I'm totally honest. Most of it comes from my head but such as the 10mm ally plate stuff I got most of the inspiration for that from big bro (propellor) all the shapes are drilled,sawn,filed and sanded by hand as are the stuff on "Norman" Andy 's mighty Enfield. The list goes on but I don't want to bore everyone. Like I say hopefully it will be down at Stafford fingers crossed🤞🤞..... cheers Michael
